characteristic typical min/max ta= 25 oc ta = -55 oc to +85 oc frequency 10 - 800 mhz 10 - 800 mhz typical intermodulation performance at 25 oc second order harmonic intercept point ....... +39 dbm (typ.) second order two tone intercept point ........ +33 dbm (typ.) third order two tone intercept point ............ +26 dbm (typ.) legend +25 oc +85 oc - - - - - - -55 oc power vdc +15 +15 ma 45 47 max. rf amplifier model tm9118pm available as: tm9118pm, 4 pin to-8 (t4) tn9118pm, 4 pin surface mount (sm3) fp9118pm, 4 pin flatpack (fp4) BX9118PM, connectorized housing (h1) features ! ! ! ! ! medium gain: 14.7 db typical ! ! ! ! ! output power: +16 dbm typical ! ! ! ! ! operating temp. -55 oc to +85 oc ! ! ! ! ! environmental screening available note: care should always be taken to effectively ground the case of each unit. noise figure (db) 4.5 5.5 max. vswr in <1.5:1 2.0:1 max. out <1.5:1 2.0:1 max. reverse isolation (db) -19 -18 max. power @ 1 db comp. (dbm) +16 +15 min. gain (db) 14.7 13.5 min. specifications typical performance data maximum ratings ambient operating temperature ................ -55oc to +100 oc storage temperature ................................. -62oc to +125 oc case temperature .................................................. +125 oc dc voltage .......................................................... +18 volts continuous rf input power .................................. +13 dbm short term rf input power ...... 50 milliwatts (1 minute max.) maximum peak power .................... 0.5 watt (3 sec max.) 3/31/04 frequency typical 100 hz 1 khz 10 khz 100 khz 1 mhz guarantee (min.) -156 -164 -167 -167 -160 -168 -171 -171 -171 -167 guaranteed phase noise performance (dbc/hz) phase noise (dbc/hz) 2.0 1.5 1.0 2.0 1.5 1.0 2 16 14 12 + 18 - 5 - 10 - 15 - 20 - 25 13 15 start 10 mhz stop 800 mhz start 10 mhz stop 800 mhz start 10 mhz stop 800 mhz start 10 mhz stop 800 mhz start 10 mhz stop 800 mhz start 10 mhz stop 800 mhz 6 5 4 3 + 16 + 15 + 14 + 17 10k 1k 100k 100 -140 -150 -160 -170 -180 * -130 _________guarantee __ __ __ __typical -190 residual phase noise test conditions carrier frequency: 600 mhz power output: +15.5 dbm temperature: 25 c agilent es5500 system gain (db) noise figure (db) 1 db comp. (dbm) input vswr output vswr reverse isolation (db) spectrum microwave 2144 franklin drive n.e. palm bay, florida 32905 ph (888) 553-7531 fax (888) 553-7532 spectrum microwave 2707 black lake place philadelphia, pennsylvania 19154 ph (215) 464-4000 fax (215) 464-4001 www.spectrummicrowave.com
|