?2012 tyco electronics corporation, a te connectivity ltd. company all rights reserved *trademark te connectivity, te connectivit y (logo), and te (logo) are trademarks. other logos, product and/or company names may be tradem arks of their respective owners. 1 of 1 instruction sheet tooling assistance center 1-800-722- 1111 product information 1-800-522-6752 this controlled document is subject to change. for latest revision and regional customer service, visit our website at www.te.com 408-8639 extraction tool 1583190-1 23 mar 12 rev a figure 1 1. introduction extraction tool 1583190-1 is designed to extract mini power drawer contacts 1489128-[ ] from mini power drawer vertical receptacles and plug connectors 1489701-1. reason for revision is provided in section 6, revision summary. 2. description the extraction tool, made of stainless steel, features a handle with an extraction tip. the tip will enter the contact cavity of the connector and depress the locking latch on the contact. this will enable the contact to be pulled out from the rear of the connector. see figure 1. 3. extraction procedure (figure 2) 1. position tool in front of the connector with tip entering the mating side of the connector. 2. push the tool into the contact cavity on the locking lance side of the connector. 3. extraction tool should bottom on the outside shoulders of the tool. 4. with tool in place, gently pull on the wire of the contact and remove. 5. repeat this procedure for any additional contacts that may need removed. 4. repair and replacement use extraction tool 1583190-1 to remove individual contacts from housings for replacement or for relocation to another housing cavity. damaged or worn contacts may be replaced provided there is sufficient slack, after re-stripping the wire, to insert the new contact. do not re-use damaged or worn contacts. instead, replace them with new contacts and discard the old ones. 5. tool reordering information extraction tool 1583190-1 is not repairable and should be replaced when it is worn or damaged. additional tools can be purchased from: customer service (038-035) tyco electronics corporation po box 3608 harrisburg pa 17105-3608 6. revision summary ? new logo figure 2 extraction tool 1583190-1 ! caution mating side of connector gently pull on wire and remove tool shoulder original instructions
|
